A male-to-male reducer stepping AN10 down to AN6, both ends carrying the standard 37-degree AN flare. Skipping two sizes in a single fitting is useful when a large supply or return line has to terminate at a considerably smaller component port, saving you from chaining two reducers together. Be deliberate about it though: a sharp step from AN10 to AN6 concentrates restriction at that point, so it is better placed at the end of a run than in the middle of a high-flow section. Both ends being male, it mates to female swivel hose ends or female couplers. Flare joints seal on the cone, so no sealant or tape is needed.
Male to Male Reducer AN10 AN6
An AN10 to AN6 male-to-male reducer, a two-size step that lets a large-bore line terminate at a much smaller AN component port.
AN Adapters
Male to Male Reducer AN10 AN6
R64.99
An AN10 to AN6 male-to-male reducer, a two-size step that lets a large-bore line terminate at a much smaller AN component port.
Reviews
There are no reviews yet.