The extended-body AN10 90° PTFE hose end. At AN10 the hose is heavy and the bend radius is large, so the extra length of this variant is genuinely useful: it moves the hose entry clear of raised bosses, sump flanges and cooler mounting plates, letting the bend develop in open air instead of jammed against a casting. That reduces the standing side load a forced bend would otherwise impose on the sealing face. Apart from the longer neck it behaves exactly like the standard AN10 90° end, with a 37° flare seal and a ferrule sized to grip PTFE liner. Fit to PTFE-lined braided hose only. Assemble with a square cut and a proper braid flare, tighten to seat rather than crush, and support the run with P-clips.